1.aerated block cutting machine

aerated block cutting machine as the main equipment in the production process of aerated concrete, its quality is good or bad, the level of cutting accuracy directly affects the quality of aerated block. My company's JQF series of flip aerated block cutting machine, with high efficiency, high degree of automation.

2. aerated block cutting machine main features:

1. The model structure is simple and practical, easy to install and maintain;

2. After the blank is turned over, the width of the blank is 600mm and the height is 1200mm, so the cutting steel wire is shorter, so it is not easy to break, not easy to drift, and the cutting accuracy is high;

3. The longitudinal cutting device is walking (the blank is fixed on the cutting table) to complete the longitudinal cutting. The horizontal cross-cutting device adopts screw drive to keep the cross-cutting frame lifting drive consistent and ensure cutting accuracy;

4. The blank body walks, the aerated block cutting machine group is fixed, and different cutting functions are completed through different equipment positions, so it can also assist in configuring the corresponding notch processing or vacuum adsorption unit;

5. In addition to the production of blocks, this machine can also produce plates, and cut the blank on six sides, so the quality of the products is not affected by the mold oil and mold deformation.

6. An additional cutting and turning table can be configured to turn over the blank after cutting is completed, which is convenient to remove the waste of the bottom plate surface and then turn back to the initial state.

7. Highly intelligent operation and management, the use of PLC centralized control, with the frequency converter to achieve the entire cutting process fully automatic operation.

8. The operation of the equipment is simple and convenient. The cutting process (turning, slitting and crosscutting) of this machine is completed in different stations respectively, and the cutting and walking are controlled in different devices. As a result, the work is simplified and the operation and maintenance are convenient.

3. aerated block cutting machine working principle:

a turning spreader, demolding and placing the blank together with the side plate of the mold on the cutting table. The longitudinal cutting device drives itself to walk and cut the blank placed on the cutting table through the motor. After cutting, it walks to the pause position. The transverse cutting device drives itself to walk to the center of the blank body through the motor to stop and then carry out horizontal cutting. The transverse cutting frame vertically falls and cuts from top to bottom until it.

4.aerated block cutting machine working mode:

(1) Trolley walking: the pre-cured blank is turned over 90 degrees in the air with the mold, then the blank is placed on the cutting machine, and the mold frame is removed by the demoulding mechanism. Then the horizontal cutting car carries out horizontal cutting. After the horizontal cutting is completed, the cross-cutting car is positioned to carry out vertical cutting from top to bottom. After the cutting is completed, the cross-cutting car is reset, and the blank is hoisted, and the horizontal cutting car is reset.

(2) Walking of the blank: The pre-cured blank is turned over 90 degrees in the air with the mold, then the blank is placed on the cutting trolley or roller table, and the mold frame is removed by the demoulding mechanism. The billet is cut horizontally by the trolley or roller table. After cutting, the billet continues to move to the cross-cutting position for horizontal cutting. After cutting, the billet is lifted by the crane.